Jetson AGX Orin Developer Kit

This page shows how to flash a Jetson AGX Orin Developer Kit with LmP artifacts.

Preparation

  1. On your factory, click on the latest platform-devel build:
../../_images/generic-steps-1.png

2. Expand the run for jetson-agx-orin-devkit and look for the lmp-factory-image-jetson-agx-orin-devkit.tegraflash.tar.gz artifact:

../../_images/jetson-agx-orin-devkit_artifacts.png
  1. Unzip the downloaded file:
tar -xvf lmp-factory-image-jetson-agx-orin-devkit.tegraflash.tar.gz

The script used for flashing is doflash.sh.

Hardware Preparation

Set up the board to boot into recovery mode:

../../_images/jetson-agx-orin-devkit.png

Fig. 99 jetson-agx-orin-devkit

  1. Connect the USB cable in the base board Type-C connector (10) to the host machine.

  2. Press and hold down the Force Recovery button, then either press the Reset button (if already powered) or press the Power button, releasing both buttons in the end.

    To check if the board is in recovery mode lsusb can be used to check if a device from vendor 0955 (NVIDIA) is available:

    host:~$ lsusb | grep 0955
Bus 001 Device 014: ID 0955:7023 NVIDIA Corp. APX

    This device is only available when the board successfully booted in recovery mode.

  3. OPTIONAL: For UART output connect a USB cable in the base board USB Micro B connector (9) to the host machine.

Flashing

  1. With the board powered in recovery mode, flash the board:
sudo ./doflash.sh

This can take a few minutes to complete. The process can be watched from the host console or UART output.

  1. Once the flashing procedure finishes, reset the board to boot the installed LmP image.