i.MX 8M Plus Evaluation Kit With SE050ARD

This document walks through the steps of installing a FoundriesFactory® image with SE050 hardware enabled onto the NXP® imx8mp-lpddr4-evk, connected to the NXP OM-SE050ARD development platform.

Note

An image created in a Factory with SE050 enabled does not boot on boards without the SE050 properly attached.

Attaching the SE050

Using four male to male jumper wires (Arduino Compatible Pin size) connect the two boards as shown:

../../_images/imx8mp-lpddr4-evk_J22.png

Fig. 56 imx8mp-lpddr4-evk

../../_images/imx8mp-lpddr4-evk_J22_pinout.png

Fig. 57 imx8mp-lpddr4-evk i2c pinout

../../_images/se050ard.png

Fig. 58 SE050ARD

Connect the signals as follows:

Signal imx8mp-lpddr4-evk OM-SE050ARD
SCL J22 pin 3 J2 pin 10
SDA J22 pin 5 J2 pin 9
VDD_3V3 J22 pin 1 J8 pin 4
GND J22 pin 7 J2 pin 7

Be sure that the jumpers on the SE050 evaluation board are set as shown:

../../_images/se050ard_jumpers.png

Fig. 59 SE050 Jumper Settings

The connected boards should look like this:

../../_images/se050ard_imx8mp.jpg

Fig. 60 Wire Connections Between Boards

Installing the FoundriesFactory Image

Download the images that have the SE050 enabled from the Factory. Follow the instructions in i.MX 8M Plus Evaluation Kit.

Note

A reference on the needed changes to enable the SE050 middleware can be found in Enabling SE05X.