i.MX 8M Quad Evaluation Kit with SE050ARD

This page walks through walk installing a FoundriesFactory® image with SE050 hardware enabled onto the NXP® imx8mqevk, connected to the NXP OM-SE050ARD development platform.

Note

An image created in the Factory with SE050 enabled will not boot on boards without the SE050 properly attached.

Attaching the SE050

Using four male to male jumper wires (Arduino Compatible Pin size) connect the two boards as shown:

../../_images/imx8mqevk_J801.png

Fig. 49 imx8mqevk

../../_images/imx8mqevk_J801_pinout.png

Fig. 50 imx8mqevk i2c pinout

../../_images/se050ard.png

Fig. 51 SE050ARD

Connect the signals as follows:

Signal imx8mqevk OM-SE050ARD
SCL J801 pin 1 J2 pin 10
SDA J801 pin 3 J2 pin 9
VDD_3V3 J801 pin 5 J8 pin 4
GND J801 pin 2 J2 pin 7

Be sure that the jumpers on the SE050 evaluation board are set as shown:

../../_images/se050ard_jumpers.png

Fig. 52 SE050 Jumper Settings

The connected boards should look like this:

../../_images/se050ard_imx8mq.png

Fig. 53 Wire Connections Between Boards

Installing the FoundriesFactory Image

Download the images that have the SE050 enabled from the Factory. Following the instructions in i.MX 8M Quad Evaluation Kit.

Note

A reference on the needed changes to enable the SE050 middleware can be found in Enabling SE05X.