Getting Started Tutorial

Start here for a step by step tutorial on how to install the microPlatforms, then use them to set up an end-to-end IoT demonstration system using the OMA Lightweight M2M (LWM2M) protocol.

Note

If you are only interested in installing one of the microPlatforms, you can go directly to Install Linux microPlatform or Install Zephyr microPlatform.

A block diagram of this system is shown here, and though it is not explicitly shown, one or more IoT devices can connect to the network through the same gateway.

Using this demonstration system, you can:

• See live data readings from your devices using the Leshan web application

• Send commands to the device, such as turning on and off an LED

• Use Leshan to update your IoT device firmware

• Secure your network communication using the DTLS protocol

To set up and use this system, follow these pages in order.

• Dependencies
• Install microPlatforms
  • Install Linux microPlatform
    • Install Base microPlatform
    • Deploy nginx Container
    • Next Steps
    • Reporting Issues
  • Install Zephyr microPlatform
    • Set up Build Environment
    • Install and Set Up a Toolchain
    • Install the Zephyr microPlatform
    • Connect to the Board’s Console
    • Build and Flash MCUboot
    • Build and Flash “Hello World” for MCUBoot
    • Change the Application and Reflash
    • Next Steps
    • Reporting Issues
• Set Up Basic LWM2M System
• Prepare the System
  • Set up IoT Gateway
  • Set up IoT Device(s)
• Use the System
  • Read and Write Objects
  • Initiate a Firmware Update
  • Monitor for a Completed Transfer
  • Execute the Update
  • Reporting Issues
• LWM2M System With DTLS
  • Generate and Flash Credentials Partition
  • Build and Flash IoT Device With DTLS Enabled
  • Provision Leshan With Device Token
  • Use the System
• Using Other Zephyr Boards