LWM2M System With DTLS

This page describes how to enable DTLS-based LWM2M communication between the gateway and IoT devices in the basic system you’ve already set up.

Important

These instructions assume you are using a Zephyr-supported nRF52840 based product, such as the nRF52840-DK development kit or the Reel Board badge.

Warning

This is an experimental feature, with important security limitations.

  • The firmware update procedure uses plain HTTP, rather than LWM2M over DTLS. This leaks the contents of the updated firmware binary. This can be used in denial of service and information disclosure attacks, but the MCUBoot binary will still refuse to boot unsigned binaries.

  • The Leshan server still allows unauthenticated HTTP access to the IoT devices via its user interface and REST API. For example, this is used below to provision the device token, which leaks it over the local network to any eavesdropper. It also allows interacting with any device objects using an unauthenticated and unencrypted interface.

Generate and Flash Credentials Partition

You first need to generate a binary blob containing device credentials to use, and flash it onto the device.

From the ZMP installation directory, run a command like this:

./zmp-samples/dm-lwm2m/scripts/gen_cred_partition.py --device-id=deadbeef --device-token=000102030405060708090a0b0c0d0e0f --output=cred.bin

The arguments are as follows.

  • --device-id is a public identifier for the device. This is currently limited to eight hexadecimal characters.

  • --device-token is a secret, device-specific token value (i.e., the token must be different for each device on the network). This is a sequence of 32 two-character hexadecimal values, each representing a byte. In the above example, the first byte is 0x00, the second is 0x01, etc.

  • --output is the output file which will contain the binary.

Now flash the partitition to your device. Inspect your board’s device tree in the build directory for its correct location on the device flash.

Build and Flash IoT Device With DTLS Enabled

You now need to re-build and re-flash the application with DTLS enabled, along with the credentials partition (the location of the credentials partition is set by your board’s device tree overlay file). For example, to build for reel_board:

west build -s zmp-samples/dm-lwm2m -d build-dm-lwm2m-dtls -b nrf52840_pca10056 -- -DOVERLAY_CONFIG=overlay-dtls.conf
west sign -t imgtool -d build-dm-lwm2m-dtls -- --key mcuboot/root-rsa-2048.pem
west flash -d build-dm-lwm2m-dtls --hex-file zephyr.signed.hex

Provision Leshan With Device Token

Now use the Leshan web interface to provision the device ID and token. If using the demonstration server, this interface is available here:

https://mgmt.foundries.io/leshan/#/security

Use the System

You should now be able to use the system with DTLS enabled in the same ways as the basic system.