i.MX 8MQuad Evaluation Kit with SE050ARD¶
This document will walk a developer through the steps of installing a FoundriesFactory image with the SE050 hardware enabled onto the NXP imx8mqevk that is connected to the NXP OM-SE050ARD development platform.
An image created in the factory with the SE050 enabled will not boot on boards without the SE050 properly attached.
Attaching the SE050¶
Connect the OM-SE050ARD Arduino Compatible Development Kit to the imx8mqevk as follows:
Using four male to male jumper wires (Arduino Compatible Pin size) connect the two boards.
Connect the signals as follows:
|SCL||J801 pin 1||J2 pin 10|
|SDA||J801 pin 3||J2 pin 9|
|VDD_3V3||J801 pin 5||J8 pin 5|
|GND||J801 pin 2||J2 pin 7|
Be sure that the jumpers on the SE050 evaluation board are set as follows:
Lastly the connected boards should look like this:
Installing the FoundriesFactory Image¶
Download the images that have the SE050 enabled from the factory following the instructions in the iMX8MQevk board.