i.MX 8MQuad Evaluation Kit with SE050ARD¶
This document will walk a developer through the steps of installing a
FoundriesFactory image with the SE050 hardware enabled onto the NXP
imx8mqevk that is connected to the NXP OM-SE050ARD development platform.
An image created in the factory with the SE050 enabled will not boot on boards without the SE050 properly attached.
Attaching the SE050¶
Using four male to male jumper wires (Arduino Compatible Pin size) connect the two boards as follows:
Connect the signals as follows:
|SCL||J801 pin 1||J2 pin 10|
|SDA||J801 pin 3||J2 pin 9|
|VDD_3V3||J801 pin 5||J8 pin 4|
|GND||J801 pin 2||J2 pin 7|
Be sure that the jumpers on the SE050 evaluation board are set as follows:
Lastly the connected boards should look like this: